Cart
0
Product
Products
(empty)
No products
To be determined
Shipping
$0.00
Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart.
There is 1 item in your cart.
Total products
Total shipping
To be determined
Total
Sale!
View larger
View larger
ASTM D3354
New product
ASTM D3354 2015 Edition, April 1, 2015 Standard Test Method for Blocking Load of Plastic Film by the Parallel Plate Method
More info
Description / Abstract:
This test method yields quantitative information regarding the
degree of blocking (unwanted adhesion) existing between layers of
plastic film. It is not intended to measure susceptibility to
blocking.
By this procedure, the film-to-film adhesion, expressed as a blocking load in grams, will cause two layers of film with an area of contact of 100 cm2 to separate. The test method is limited to a maximum load of 200 g.
The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
NOTE 1—This test method is similar to ISO 11502 Method B, but is not technically equivalent.
*A Summary of Changes section appears at the end of this standard
By this procedure, the film-to-film adhesion, expressed as a blocking load in grams, will cause two layers of film with an area of contact of 100 cm2 to separate. The test method is limited to a maximum load of 200 g.
The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
NOTE 1—This test method is similar to ISO 11502 Method B, but is not technically equivalent.
*A Summary of Changes section appears at the end of this standard