AASHTO T 65M/T 65

Description / Abstract: This test method covers procedures for determining the mass [weight] of coating on iron or steel sheet, wire, and other articles in which the coating is zinc or a zinc alloy, such as zinc-5 percent aluminum (including zinc-5 percent aluminum-mischmetal and zinc-5 percent aluminum-0.1 percent magnesium) or 55 percent aluminum-zinc. In the body of this test method, reference to zinc coating shall be interpreted to also include zinc-alloy coating except where specifically stated otherwise.

The final results determined by this test method shall be expressed in SI units or inch-pound units, depending on the units used in the material specification to which the results are to be compared. Certain portions of the procedure involving determination of specimen mass [weight] traditionally have been performed in SI units, and corresponding inch-pound units are not included.

For sheet products, the final results are expressed as either coating mass [weight] total both sides, or coating mass [weight] separately on each side, depending on the specified requirements.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 5.1.

Current regulation codes and hazard classifications for chemicals used in this test method are listed in R 16.